Stribog Short Stroke Buffer SP9A1 gen2

$15.00

During operation with the stock components, the bolt can move back far enough to expose a cut out inside the receiver where, under the right circumstances, spent shell casings can fall into and become lodged thus locking up the function of the fun. Not good!

This short-stroke buffer for the Grand Power Stribog is a cheap, simple, and easy solution to getting casings lodged in the receiver during operation; it limits the amount that the bolt can travel back just enough to not expose that cut out in the receiver.

The slightly shortened stroke can also help during rapid firing operations with the correct ammo, since the shortened stroke takes less time for the bolt to return to firing position, thus allowing quicker following shots to be taken.

  • Made from high-quality Delrin it delivers smooth and flawless operation. 

  • Made from high-quality materials 100% in the good old USA!

During operation with the stock components, the bolt can move back far enough to expose a cut out inside the receiver where, under the right circumstances, spent shell casings can fall into and become lodged thus locking up the function of the fun. Not good!

This short-stroke buffer for the Grand Power Stribog is a cheap, simple, and easy solution to getting casings lodged in the receiver during operation; it limits the amount that the bolt can travel back just enough to not expose that cut out in the receiver.

The slightly shortened stroke can also help during rapid firing operations with the correct ammo, since the shortened stroke takes less time for the bolt to return to firing position, thus allowing quicker following shots to be taken.

  • Made from high-quality Delrin it delivers smooth and flawless operation. 

  • Made from high-quality materials 100% in the good old USA!

Compatible with the SP9A1 and SP9A3 gen2 guns only

  • Older A1 guns have two rods that run between the bolt and buffer block

  • The older two-rod guns are not compatible with this buffer block 

  • This buffer block is designed to be used in conjunction with the stock factory buffer block (see product pictures)

  • After removing the recoil assembly, simply remove the retainer that holds the coil spring, slide this buffer block over the spring, then compress the spring and replace the retainer

  • All set! 

It is recommended to have professional installation on all parts. 

Don’t forget to lube your guns and moving parts correctly! 

100% made in the good old USA! FREE SHIPPING!